Read all safety instructions and guidelines found below. Commit to always wearing a life jacket and make safety a priority on the water.

Please read carefully prior to use.

Failure to follow safety instructions and precautions may result in serious personal injury or death.

The warnings, cautions, and instructions discussed in this manual cannot cover all possible conditions or situations that could occur.

It is up to the operator to use common sense while using this product.

Do not allow persons to operate or assemble the Lake Snake until they have read this manual and have a thorough understanding of how it works.

This product is not a life saving device. A Type III personal flotation device (PFD) is required at all times while on board.

Do not use the Lake Snake under the influence of drugs or alcohol.

Do not use this the Lake Snake if you cannot swim.

Do not use the Lake Snake in rough waters, in storm-like conditions, or when lightning is present.

Use caution when getting on and off the Lake Snake.

Consult your physician before using the Lake Snake.

Use this product only if you know you are in good physical health.

Users of this product are responsible for their own safety.

Do not over inflate. Only inflate within recommended PSI range.

Inspect the Lake Snake for any worn or defective parts prior to use and replace as necessary.

Do not use if product is defective.

Do not use the Lake Snake near motorized boats.

While in use, ensure the Lake Snake is in deep enough water, free from hazardous materials.

Always carry the Lake Snake to the water, do not drag it across the ground.

If under 18, always use the Lake Snake under adult supervision.

Users of the Lake Snake assume all risk and liability.

Prepare the Inflation Valve: Ensure the valve pin (center pin) on the inflation valve is in the up position. When the pin is up, air can be pumped in, and the Lake Snake will not lose pressure when the pump hose is removed.

Inflate the Lake Snake: Connect the pump hose and inflate the Lake Snake to 6–10 PSI, depending on your preferred rigidity. The pump's gauge will begin registering pressure around 3–5 PSI.

If the internal pressure reaches the maximum, the pressure regulator will automatically release small amounts of air.

Using Electric Pumps: Electric pumps and air compressors can also be used for inflation. We offer adapters and e-pumps if manual pumping is difficult. If you already own an electric pump, feel free to use it—off-brand pumps will not void your warranty or damage the dock.

Checking the Valves (Periodic Maintenance): Once a year, use the black valve wrench to ensure both the air fill valve and pressure relief valve are snug.

Warning: Do not completely unscrew either valve.

Anchoring or tethering the Lake Snake can be done by tethering with a mooring bungee or a stretchy rope to an anchor, boat, dock, or other Paddle North product. It is recommended to anchor from multiple D-rings to ensure wind can’t get under the Lake Snake. 15 - 20 lb anchor is typically heavy enough for most bodies of water.

Prepare for Deflation: Deflating the Lake Snake only takes a few minutes. Before rolling or storing, make sure the surface is dry.

Release the Air: Open the valve cap and press down on the valve pin (center pin). The pin will lock in the down position, allowing air to flow out freely. Let the Lake Snake sit for a few minutes as it fully deflates.

Optional: Use a Pump to Speed Up Deflation Both the electric pump and the manual pump can assist with deflation. Simply switch the hose connection to the deflate setting to vacuum out the remaining air.

Storing the Lake Snake inflated or deflated is acceptable. If storing deflated, ensure that the Lake Snake is completely dry. If storing in a below freezing temperature, it is better to have the Lake Snake unrolled where the seams won’t be stressed.