Read all safety instructions and guidelines found below. Commit to always wearing a life jacket and make safety a priority on the water.

Please read carefully prior to use.

Failure to follow safety instructions and precautions may result in serious personal injury or death.

The warnings, cautions, and instructions discussed in this manual cannot cover all possible conditions or situations that could occur.

It is up to the operator to use common sense while using this product.

Do not allow persons to operate or assemble the Lake Lounger until they have read this manual and have a thorough understanding of how it works.

This product is not a life saving device. A Type III personal flotation device (PFD) is required at all times while on board.

Do not use the Lake Lounger under the influence of drugs or alcohol.

Do not use this the Lake Lounger if you cannot swim.

Do not use the Lake Lounger in rough waters, in storm-like conditions, or when lightning is present.

Use caution when getting on and off the Lake Lounger.

Consult your physician before using the Lake Lounger.

Use this product only if you know you are in good physical health.

Users of this product are responsible for their own safety.

Do not over inflate. Only inflate within recommended PSI range.

Inspect the Lake Lounger for any worn or defective parts prior to use and replace as necessary.

Do not use if product is defective.

Do not use the Lake Lounger near motorized boats.

While in use, ensure the Lake Lounger is in deep enough water, free from hazardous materials.

Always carry the Lake Lounger to the water, do not drag it across the ground.

If under 18, always use the Lake Lounger under adult supervision.

Users of the Lake Lounger assume all risk and liability.

1. Take the black valve wrench from the repair kit and ensure the air fill valve and the pressure relief valve are tight. Typically, once a year you may need to retighten these valves with the wrench. Warning: Do not ever completely unscrew the valve.

2. Inflating the Lake Lounger: Inflating the Lake Lounger will take 4-7 minutes, although this does depend on the target psi.

3.1 Ensure the valve pin is in the up position. When the valve pin is up, you can still pump air into the Lake Lounger, but it won’t lose any pressure when the pump hose is disconnected.

3.2 Connect the pump hose and inflate the Lake Lounger to 8-10 psi, depending on how rigid you'd like it to be. The pump has a PSI gauge, it won’t start reading a pressure until the Lake Lounger reaches at least ~3-5 PSI. The Lake Lounger has a max air capacity of 10 PSI. The pressure regulator will activate and slowly let air out if max capacity is ever reached.

3.3. Electric pumps and air compressors can also be used. We have adapters and e-pumps if inflating manually is an obstacle. If you have an existing e-pump, feel free to use it. You won’t void any warranty or do any damage to the dock by using an off-brand pump.

1 Deflating the Lake Lounger takes just a few minutes. Dry off the Lake Lounger before rolling up and putting away for storage.

1.2 Open the valve cap and press down on the center pin for the air valve. The pin will lock in the down position and let all of the air out. Let it sit for a few minutes while air flows out of the Lake Lounger.

Optional: Our electric pump does vacuum the air out by switching the hose connector to deflate on pump.

Storing the Lake Lounger inflated or deflated is acceptable. If storing deflated, ensure that the Lake Lounger is completely dry. If storing in a below freezing temperature, it is better to have the Lake Lounger unrolled where the seams won’t be stressed.